PLEASE NOTE: If you run into any issues with the transfer and can't get it to work, make sure the drive doesn't remain plugged in to the new Tablo overnight - when Tablo does its nightly maintenance, the drive may get formatted. The process is complete once the Tablo’s LED is solid. Once your new Tablo is finished downloading the database it will reboot. Step 4: After a few seconds your Tablo’s LED will begin pulsing.Īt this point, it is transferring your original Tablo’s database to your new Tablo. Step 3: Attach the hard drive, Ethernet and power (in that order) to your new Tablo. Note: If your Tablo is using a SATA drive, remove the power adaptor from the Tablo before removing the SATA drive. You can also unplug your original Tablo, as it will no longer be needed. Step 2: Remove the USB drive from your original Tablo and set it aside. Wait for the Tablo’s blue LED to go solid. Step 1: Reboot your original Tablo with the hard drive attached using the blue reset button on the back of the Tablo. Our support team can also check this for you, so don't hesitate to send us a ticket. The new Tablo must be on the same firmware version as your original unit. If you have connected to your new Tablo already, note its firmware version: you can find this at the bottom of the Tablo Settings screen. Note: Recordings cannot be moved from Network Connected Tablo models to TV-Connected Tablo models (and vice versa). If you've already run a channel scan on your new Tablo, you will need to factory reset it for these instructions to work. Note: For this process to work, your NEW Tablo must be taken directly out of the box. If you replace your Tablo DVR the process below will allow you to migrate your existing recordings stored on an external USB disk drive or SATA drive (devices using built in storage like the Tablo DUAL 128GB are not supported) and schedule data to your new unit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |